|
[Sponsors] |
April 4, 2007, 02:43 |
Expressions with more that one variables
|
#1 |
Guest
Posts: n/a
|
Hi to everyone,
How can I evaluate "Expressions" with more that one variables, which I have already set in Pre- and the Res. file is also created!? any comments would be highly appreciated... Regards, Houman I get this error message: ERROR #001100279 has occurred in subroutine ErrAction. Message:CEL_VALUE requested the evaluation of a single valued CEL expression. However, the expression specified for "Monitor Point 1" is not single valued. One or more sub-expressions yield field values band must be corrected to yield single values. |
|
April 5, 2007, 09:07 |
Re: Expressions with more that one variables
|
#2 |
Guest
Posts: n/a
|
If you use an expression for a Monitor Point, it has to evaluated to a single number, not a field variable. You can use the callback functions (areaAve, volumeInt etc) to get single numbers for field variables on a specified locator.
|
|
April 5, 2007, 09:34 |
Re: Expressions with more that one variables
|
#3 |
Guest
Posts: n/a
|
Hi Stumpy,
thanks for your reply, the fact is the my expression (ds=26*dR*(dR^2*g * Water at RTP.density /SuTen)^-0.5*(g *dR ^3/KV^2 )^-0.12*(uG /sqrt(g *dR))^-0.12) calculates the bubble diameter (of the gas in a bubble column with 2 phases) so I just wanted to see the result of ds (bubble diameter) in the output file of the CFX. could you please instruct me in this regard. thanks in advance, Houman |
|
April 5, 2007, 11:34 |
Re: Expressions with more that one variables
|
#4 |
Guest
Posts: n/a
|
To avoid the error you got, remove the monitor point.
If you created this expression in CFX-Pre, then it will appear in CFX-Post also. You can create a new variables in CFX-Post (on the Variables tab) that is equal to this expression. |
|
April 6, 2007, 08:06 |
Re: Expressions with more that one variables
|
#5 |
Guest
Posts: n/a
|
Thanks for the tip... it really helped a lot...
best regards, houman |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ADDITIONAL VARIABLES LIMITERS | N.P | CFX | 5 | December 1, 2011 07:47 |
Grouping expressions in CEL | foo7 | CFX | 4 | September 21, 2011 09:15 |
$FOAM_USER_APPBIN & LIBBIN variables not set | rassilon | OpenFOAM Installation | 2 | February 16, 2010 20:54 |
PHI file structure | Eugene | Phoenics | 9 | November 2, 2001 22:00 |
Saving variables on a user patch with physical coordinates | Zoltan Turzo | CFX | 2 | April 20, 2000 15:05 |