Home > Forums > CFX

icem

Mark Forums Read

Reply

April 6, 2007, 12:56	icem	#1
suresh Guest Posts: n/a	Can we change asscociation of edge manually? I mean can we reverse the association direction? which is best method for association? is it thru vertices or curve or faces?

Reply

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ANSYS Meshing] Workbench 13: Structured Hexa Meshes	rooftop	ANSYS Meshing & Geometry	17	May 31, 2012 16:39
PEM Fuel cell module meshes. ICEM vs workbench	aarvay	FLUENT	7	May 5, 2012 13:52
Design Modeler to ICEM.....	Joe	CFX	0	January 24, 2008 03:39
ICEM 10 mesh scale foe CFX	Korsh Mik	CFX	2	October 7, 2005 09:07
ICEM CFD 5.1 Hex-Tet mesh merging failure	bogesz	CFX	1	January 29, 2005 06:46

All times are GMT -4. The time now is 13:14.