|April 16, 2007, 02:25||
(ICEM CFD)import geometry from Tecplot
I use ANSYS ICEM CFD to import geometry from Tecplot, but I can't set up any surface with boundary condition in this model.
After exporting these domains to CFX4(filetype *.geo), CFX 5.7.1 found only a total mesh of structure, and I can't set up the "inlet" or "outlet" boundary surface I want.
So I install Ansys workbench and try to indicate the position of "inlet" or "outlet" condition I want. Now I have no idea how to do it.
Would you please give some advices to solve this problem?
A good day to you.
|Thread||Thread Starter||Forum||Replies||Last Post|
|geometry import problems (STEP into ICEM)||Toralf||CFX||10||March 7, 2014 22:17|
|[ICEM] importing a geometry from Turbogrid to ICEM||c120613||ANSYS Meshing & Geometry||1||May 14, 2013 23:59|
|icem hexa - load different blockings for each part of geometry???||Catthan||ANSYS Meshing & Geometry||2||May 28, 2010 11:27|
|Design Modeler to ICEM.....||Joe||CFX||0||January 24, 2008 04:39|
|icem: import tecplot mesh||David||CFX||4||August 9, 2006 08:30|