 |
 |
 |
|
|
|
[Sponsors] | ||||
May 8, 2007, 15:24
|
Hexa Meshing with ICEM & CFX
|
#1 |
|
Guest
Posts: n/a
|
Hello everybody. I have made an hexa pre-mesh of a pipe but I don't know how to continue in order to export it to the CFX. I don't even know how to do the volumetric meshing (if I have to do it). If anyone could help me with this I'll appreciate. Thanks. Bye.
|
|
|
||
|
May 8, 2007, 17:23
|
Re: Hexa Meshing with ICEM & CFX
|
#2 |
|
Guest
Posts: n/a
|
You have to use the right button of your mouse. Just select Pre-Mesh, select the option to create the volume mesh. In your file system you will find a file "hex". Finally you have to convert this to unstructed CFX mesh (a msh-file). You can read this in into Pre.
Gert-Jan www.bunova.nl |
|
|
|
||
|
May 9, 2007, 19:57
|
Re: Hexa Meshing with ICEM & CFX
|
#3 |
|
Guest
Posts: n/a
|
Once you have your PRE MESH ready:
in the menu in ICEM. FILE>MESH>LOAD FROM BLOCK and then go to Output tab... and export the mesh. Hope it helps. santiago |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Remeshing in CFX using workbench meshing. | adeban | CFX | 25 | March 29, 2021 05:46 |
| [ICEM] complex 2D meshing on ICEM | kassab | ANSYS Meshing & Geometry | 26 | April 14, 2014 21:02 |
| Wind tunnel hexa meshing in ICEM CFD 12.1 | matheusguzella | ANSYS Meshing & Geometry | 1 | March 14, 2011 16:14 |
| Hexa + Tetra meshing (Hybrid) in ICEM | vmlxb6 | ANSYS Meshing & Geometry | 12 | December 27, 2010 10:18 |
| importing mesh from ICEM CFD into CFX 5 | Jay | CFX | 2 | November 12, 2002 13:46 |
Linear Mode
