CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   CFX (http://www.cfd-online.com/Forums/cfx/)
-   -   How to find hole in mesh (http://www.cfd-online.com/Forums/cfx/24002-how-find-hole-mesh.html)

prateek jain May 19, 2007 02:24

How to find hole in mesh
 
Dear friends When I mesh ICEM CFD It shows some hole How I can detect the holes in gometry. How I can repair hole in mesh also I tried hole repair but it not give what are the element in hole.

Abdul May 21, 2007 00:32

Re: How to find hole in mesh
 
hai generally the hole repair is not a fair thing to do rather you can improve your mesh by changing the mesh parameters. anyway for locating the bad mesh elements what you can do is check for mesh quality the negative elements will be shown just click on the bar of negative elements it will show where are they located.

prateek jain May 21, 2007 23:49

Re: How to find hole in mesh
 
Hi Abdul, Thanks for your suggestion,I am also try for that. Is this hole in geometry cause by hole tollerence or by the size of globale parameter mesh size.

Abdul May 22, 2007 03:26

Re: How to find hole in mesh
 
yes it could be caused b'coz of either global mesh size or surface mesh parameter. so you have check both.

prateek jain May 24, 2007 06:38

Re: How to find hole in mesh
 
To remove this hole before meshing can I proceed with surface mesh then I go for volume mesh?How can I determine the element in which hole is occours?


Pankaj May 24, 2007 07:06

Re: How to find hole in mesh
 
After defining your parts for the mesh,keep global size 1, and give mesh sizes in your part mesh set up.Then right click on your geometry>surfaces>show tetra sizes or say hexa sizes which will give u an idea about your mesh size. To see the holes in your geometry say show full and soli&wire from the same menu.And if your geom does not have any holes,then your mesh sizes may be greater so that it will not capture your geometry and will create holes. So just practice.



All times are GMT -4. The time now is 09:43.