 |
 |
 |
|
|
|
[Sponsors] | ||||
May 18, 2007, 10:23
|
boundary layer thickness from Post
|
#1 |
|
Guest
Posts: n/a
|
After the simulation completed, how can we get the boundary layer thickness from CFX-Post?
|
|
|
||
|
May 18, 2007, 22:34
|
Re: boundary layer thickness from Post
|
#2 |
|
Guest
Posts: n/a
|
No direct way to do it. You can draw a line through the flow, plot the velocity, and see where it reaches 99% of free stream velocity.
Or is there a better way? |
|
|
|
||
|
May 21, 2007, 12:59
|
Re: boundary layer thickness from Post
|
#3 |
|
Guest
Posts: n/a
|
I agree with Omer. You can find the points, where velocity becomes 99% of free stream velocity.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| A question on "Specifying Boundary Layer Deformation Smoothing" | didiean | FLUENT | 2 | January 16, 2012 21:39 |
| [snappyHexMesh] Boundary layer generation problems | ivan_cozza | OpenFOAM Meshing & Mesh Conversion | 0 | October 6, 2010 13:47 |
| Best Way to Capture Boundary Layer Thickness | Gill | FLUENT | 0 | October 18, 2008 01:03 |
| Boundary layer thickness. | raintung | FLUENT | 1 | May 22, 2003 11:21 |
| channel half width/ boundary layer thickness | Peter liang | Main CFD Forum | 3 | September 27, 2001 04:10 |
Linear Mode
