|
[Sponsors] |
May 27, 2007, 23:35 |
Unit Convertion
|
#1 |
Guest
Posts: n/a
|
Hi,
How do I set a new unit in CFX-Pre or CFX-Post? For example, Sometimes I need to show the mass flow rate as "Cubic Foot Minute", but I can't get the "Cubic Foot Minute" unit in the option>unit. Thanks a lot. |
|
May 28, 2007, 09:01 |
Re: Unit Convertion
|
#2 |
Guest
Posts: n/a
|
Dear Barii
Cubic Foot Minute is not a mass flow rate unit, but a volume flow rate.. Just type Mass Flow Rate = <your volume flow rate> * density Opaque |
|
May 28, 2007, 21:14 |
Re: Unit Convertion
|
#3 |
Guest
Posts: n/a
|
Dear Opaque,
Thanks for your help. In CFX-Post, the mass flow rate was weight per second. If I wolud like to show weight per minute, how do I set the unit? Barii |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[DesignModeler] how to define the unit convertion in workbench | just like wind | ANSYS Meshing & Geometry | 2 | April 13, 2011 07:24 |
UDF unit and FLUENT output | saifulraju | FLUENT | 4 | September 21, 2010 22:22 |
Unit for a source term | JP | CFX | 4 | July 14, 2005 14:29 |
how to search unit | lenson | Siemens | 1 | April 28, 2005 03:35 |
unit of fluent | yinyue | FLUENT | 0 | November 3, 2004 08:57 |