|
[Sponsors] |
May 29, 2007, 03:55 |
Convergence then Divergence
|
#1 |
Guest
Posts: n/a
|
Hello all, I have a question about a simulation I have, that starts converging for a good limit and if left to iterate ore it starts to diverge. in this case is it ok if I consider the results before divergence (after reaching a good limit of convergence)? or does this mean that the whole simulation is diverging and useless?
|
|
May 29, 2007, 08:58 |
Re: Convergence then Divergence
|
#2 |
Guest
Posts: n/a
|
No. Convergence is just one of the useful parameters to judge you solution. Look at imbalances too and use monitor points. When the imbalances are 0 and the monitor values are constant, and residuals are below 1e-5, then you might have a converged solution. But then you still need to perfroms checks.
Gert-Jan www.bunova.nl |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Convergence | Centurion2011 | FLUENT | 48 | June 15, 2022 00:29 |
Force can not converge | colopolo | CFX | 13 | October 4, 2011 23:03 |
Quarter Burner mesh with periosic condition | SamCanuck | FLUENT | 2 | August 31, 2011 12:34 |
Convergence of CFX field in FSI analysis | nasdak | CFX | 2 | June 29, 2009 02:17 |
Convergence then Divergence | Ryan | FLUENT | 1 | August 6, 2004 01:46 |