|
[Sponsors] |
May 16, 2007, 05:46 |
2D mesh generation!!
|
#1 |
Guest
Posts: n/a
|
Hello everybody, I am a new users of CFX. If I creat a 2D channel, say length 12mm and width 6mm, then how can I create mesh file(gtm file)using ANSYS Workbench.I wuold be very glad to him, if anybody give me the information.I face a great problem for this.My email is mmatadu@yahoo.com.
Yours Truly Sohag Korea |
|
June 4, 2007, 03:04 |
Re: 2D mesh generation!!
|
#2 |
Guest
Posts: n/a
|
I think you could refer to the tutorial 8 of Ansys Workbench. Good luck!
|
|
June 4, 2007, 05:01 |
Re: 2D mesh generation!!
|
#3 |
Guest
Posts: n/a
|
Dear Mr. Li Rong, Thanks a lot. Would you please give me information how I can use Slip boundary condition on top and Bottom wall of 2D geometry in a gaseous Phenomenon.
Yours Truly Taher |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 04:24 |
[Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 03:52 |
[ICEM] Unstructure Meshing Around Imported Plot3D Structured Mesh ICEM | kawamatt2 | ANSYS Meshing & Geometry | 17 | December 20, 2011 11:45 |
mesh generation for in-cylinder fluent simulation | hennas | ANSYS Meshing & Geometry | 2 | May 31, 2011 15:08 |
General questions on grid-based computing | Adrin Gharakhani | Main CFD Forum | 21 | June 5, 2000 13:47 |