Aabout settings of contamination model

June 20, 2007, 06:49

Hi guys! I am working a case with contamination emmision. Because I am just learning Ansys Workbench and Ansys CFX10.0 for a while, I am wondering if you would tell me whether the following settings are ok. The main purpose of the simulation is to predict CO2 distribution in the room. Please link here:http://imageshack.dk//viewimage.php?...e/u9A32626.jpg which shows the basic information about the model. A is the CO2 generation container to assure CO2 concentration is even on the surface(Blue one). I would creat a new material as CO2 in CFX-Pre, and then I will set A as a fluid subdomain in which I will set a Mass source. Is it ok?

Thank you very much!

With kind regards Li

June 22, 2007, 08:28

hi Li, in workbench, you must creat your domain and the down face with extrude of one cube with imprint face closure, i have same simulation, and i work on it but on filed. we can cooperate. my E-mail is kashi_58@yahoo.com regards eslam

June 20, 2007, 06:49	Aabout settings of contamination model	#1
Li Guest Posts: n/a	Hi guys! I am working a case with contamination emmision. Because I am just learning Ansys Workbench and Ansys CFX10.0 for a while, I am wondering if you would tell me whether the following settings are ok. The main purpose of the simulation is to predict CO2 distribution in the room. Please link here:http://imageshack.dk//viewimage.php?...e/u9A32626.jpg which shows the basic information about the model. A is the CO2 generation container to assure CO2 concentration is even on the surface(Blue one). I would creat a new material as CO2 in CFX-Pre, and then I will set A as a fluid subdomain in which I will set a Mass source. Is it ok? Thank you very much! With kind regards Li

June 22, 2007, 08:28	Re: Aabout settings of contamination model	#2
eslam Guest Posts: n/a	hi Li, in workbench, you must creat your domain and the down face with extrude of one cube with imprint face closure, i have same simulation, and i work on it but on filed. we can cooperate. my E-mail is kashi_58@yahoo.com regards eslam

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
multiphaseInterFoam for RAS turbulence model	chiven	OpenFOAM Bugs	8	December 6, 2017 02:08
help for different between les model (subgrid-scale model)	liuyuxuan	FLUENT	1	October 2, 2009 15:25
Grid resolution for full-scale and down scaled model	gravis	Main CFD Forum	0	October 2, 2009 10:27
2 stage axial turbine model convergence issues	sherifkadry	CFX	2	September 7, 2009 20:51
Advanced Turbulence Modeling in Fluent, Realizable k-epsilon Model	Jonas Larsson	FLUENT	5	March 13, 2000 03:27