 |
 |
 |
|
|
|
[Sponsors] | ||||
July 9, 2007, 09:57
|
Design Modeller Limits
|
#1 |
|
Guest
Posts: n/a
|
Hi,
I get the following error: "Error: Self intersecting or invalid profiles" from Design Modeller whenever I extrude a sketch which has a dimension greater than 500m. Does anyone know the solution to this problem? Thanks in advance, Oliver |
|
|
||
|
July 9, 2007, 10:28
|
Re: Design Modeller Limits
|
#2 |
|
Guest
Posts: n/a
|
To my knowledge, DM is limited to 1000 m, i.e. 500m left and 500 right. Make everything in mm and scale it up by a factor or 1000 in Pre.
Gert-Jan, www.bunova.nl |
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Design modeller ease to use | taw | CFX | 4 | May 2, 2011 15:51 |
| [Other] Import autocad into Design modeller | lcea | ANSYS Meshing & Geometry | 1 | December 1, 2010 13:15 |
| Import autocad into Design modeller | lcea | CFX | 0 | November 30, 2010 04:13 |
| CFX design modeller | Mirco | CFX | 2 | April 5, 2007 14:05 |
| Info: Short Course On Thermal Design of Electronic Equipment | Arnold Free | Main CFD Forum | 0 | August 10, 1999 10:18 |
Linear Mode
