|
[Sponsors] |
July 30, 2007, 14:37 |
Floating Front node
|
#1 |
Guest
Posts: n/a
|
Dear All,
I have been receiving the following 'internal error' message when I try to mesh my geometry: 'Number of floating front nodes detected = 1'. Can someone please clarify what is meant by this error? Note that I do have a section of a sphere in my geometry, which is a 360 degrees continuous surface. How can this error be resolved or avoided? your feedback would be greatly appreciated. Regards, Khaled |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Floating point exception during parallel mode of fluent | aamer | FLUENT | 10 | May 16, 2019 09:49 |
Multiple floating objects | CKH | OpenFOAM Running, Solving & CFD | 14 | February 20, 2019 09:08 |
License server not visible from master node | Charles | FLUENT | 0 | October 30, 2007 17:48 |
help, what is a floating node? | Richard | CFX | 0 | March 17, 2006 00:41 |
Front tracking | Don Hawken | Main CFD Forum | 1 | December 12, 1999 13:29 |