|August 28, 2007, 06:05||
I am trying to model water vapor condensation.
Its a pipe flow with 50 % air and 50 % Vapor(which will condense due to outside cold temp). How should i define the materials and how should i have a combination of them to use phase change models?
The outlet should show the mass fraction of condensate,vapor & air.
Can anybody sort this out?
Thanks and Regards, Pankaj.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Solid/liquid phase change||fabian_roesler||OpenFOAM||10||December 24, 2012 07:37|
|About phase change heat and mass transfer||Michael||FLUENT||2||February 13, 2011 02:49|
|Phase change||phdsantos||FLUENT||0||March 20, 2009 11:19|
|Two phase flow with phase change||Ahmad Al-Zoubi||CFX||1||November 26, 2008 04:59|
|How to model the solid-fluid phase change in CFX||ohrmond||CFX||2||May 26, 2006 06:27|