Variables
 

Hi I ran a transient simulation I am suprised that I didnt have most of the variables available in use in cfx post

What may be the reason? I couldnt reach Wall Heat Flux,Temprature,Pressure etc?

Thanks in advance Selim

Re: Variables
 

Hi,

Did you select "selected variables" in the result file options in CFX-Pre? That is probably the cause.

Glenn Horrocks

Re: Variables
 

Glenn is right. In the Transient output control try to select all the variables that you need as an output for Postprocessing them.

Or else, it would only store some default variable values.