boundary layer prediction in multiphase simulation -- CFD Online Discussion Forums

September 20, 2007, 08:20	boundary layer prediction in multiphase simulation	#1
Li Guest Posts: n/a	Hi everyone! I am interested in the mass transfer from the liquid to the air, but I never did simulations in multiphase, so I am wondering if you would tell me some your experience about it. Would you tell me if it is possible to predict boundary layter precisely above the liquid surface in CFX? And what should I be careful for when doing such simulations? The main purpose of the simulations is to find what kind of parameters will have an effect on emission of gases from the contaminant surface in a room. Thank you very much! Best Regards, Li

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[GAMBIT] 3D boundary layer and meshing problem in GAMBIT 2.4.6	prashanthreddyh	ANSYS Meshing & Geometry	1	December 20, 2011 00:35
simulation of subharmonic resonance in boundary layer transition	hadesmajesty	Main CFD Forum	0	July 30, 2010 09:00
2D airfoil simulation, turbulence, boundary layer, unstructured grid	louis.langouche@gmail.com	FLUENT	0	March 3, 2010 08:19
To thin boundary layer?	Luk	CFX	3	February 27, 2009 03:22
3D Boundary Layer	Mario	FLUENT	0	February 17, 2009 03:40

All times are GMT -4. The time now is 23:34.