HELP ICEM beginner degenerate edge -- CFD Online Discussion Forums

October 17, 2007, 12:41	HELP ICEM beginner degenerate edge	#1
guest7777 Guest Posts: n/a	hello, 1) i am going through tuorial of 2D-car and the message 'degenerate edge found' comes up. I have not found anything about this concept in the Help. 2) ICEM crashed in an earlier project when i are created a PRE-MESH and on running again does not find 'surface model' although the mesh should be 2D... I have not created any surfaces and am forced to save the files .tin and .blk before it crashes again Could you please help?

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 06:09
[ICEM] Complete beginner with ICEM	dfitz1000	ANSYS Meshing & Geometry	6	January 17, 2011 16:22
Actuator disk model	audrich	FLUENT	0	September 21, 2009 07:06
Where's the singularity/mesh flaw?	audrich	FLUENT	3	August 4, 2009 01:07
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 11:55

All times are GMT -4. The time now is 02:11.