How to input a comma in CFX-Pre/Transfor Mesh/From

November 2, 2007, 04:35

Hi, everyone, I am an new learner on CFX. Recently, when I learnt CFX according to Tutorial 10:Flow in a catalytic Converter, I have to input the following setting, but I can't input the comma like below, and the dialog box can't be dragged horizontally. "Apply Rotation > From 0, 0, 0.16

Apply Rotation > To 0, 1, 0.16"

Could anyone help me? Thanks a lot.

Susan

November 2, 2007, 07:47

Now, I found it. It is the chocked problem of the computer.

November 2, 2007, 04:35	How to input a comma in CFX-Pre/Transfor Mesh/From	#1
Susan Guest Posts: n/a	Hi, everyone, I am an new learner on CFX. Recently, when I learnt CFX according to Tutorial 10:Flow in a catalytic Converter, I have to input the following setting, but I can't input the comma like below, and the dialog box can't be dragged horizontally. "Apply Rotation > From 0, 0, 0.16 Apply Rotation > To 0, 1, 0.16" Could anyone help me? Thanks a lot. Susan

November 2, 2007, 07:47	Re: How to input a comma in CFX-Pre/Transfor Mesh/	#2
Susan Guest Posts: n/a	Now, I found it. It is the chocked problem of the computer.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ATTENTION! Reliability problems in CFX 5.7	Joseph	CFX	14	April 20, 2010 15:45
Electronics Enclosure Analysis with CFX	Simulation Engineer	CFX	1	April 22, 2009 11:08
CFX 10's solutions differ from CFX 5.7's	Atit Koonsrisuk	CFX	4	July 26, 2006 11:59
subroutine FORTRAN // CFX in Spain	spain	CFX	0	May 23, 2006 06:12
FSI using CFX and ANSYS	Bi Chang	CFX	2	May 10, 2005 04:47