|November 7, 2007, 08:51||
I am trying to use an ordinary rotational periodic interface in CFX-10, but I get the following error in the solver:
ERROR #001100279 has occurred in subroutine ErrAction. Message: Found a pair of nodes that should each be multiply connected, but only one is.
ERROR #001100279 has occurred in subroutine ErrAction. Message: Stopped in routine PER_VX2ACV
I am sure that the interface meshes match, because I have already ran it in other CFD packages with 1:1 matching. The CFX Preprocessor can also recognize it as a 1:1 matching interface, but still I am getting this solver error.
Thanks for your help, Marcelo.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Wind turbine simulation||Saturn||CFX||45||February 8, 2016 05:42|
|RPM in Wind Turbine||Pankaj||CFX||9||November 23, 2009 05:05|
|Convective Heat Transfer - Heat Exchanger||Mark||CFX||6||November 15, 2004 16:55|
|Replace periodic by inlet-outlet pair||lego||CFX||3||November 5, 2002 21:09|
|periodic grid interface||santosh||FLUENT||3||August 30, 2001 10:06|