|
[Sponsors] |
December 6, 2007, 05:47 |
ERROR IN CFX 11
|
#1 |
Guest
Posts: n/a
|
HELLO
DOES ANYONE KNOWS WHAT IS THIS ERROR MEANS? A wall has been placed at portion(s) of an INLET | | boundary condition (at 100.0% of the faces, 100.0% of the area) | | to prevent fluid from flowing out of the domain. | | The boundary condition name is: in. | | The fluid name is: Air at 25 C. | | If this situation persists, consider switching | | to an Opening type boundary condition instead. |
|
December 6, 2007, 08:23 |
Re: ERROR IN CFX 11
|
#2 |
Guest
Posts: n/a
|
perhaps it's a problem of flow recirculation in the inlet
|
|
December 6, 2007, 08:29 |
Re: ERROR IN CFX 11
|
#3 |
Guest
Posts: n/a
|
Basically, your flow is trying to escape out of your inlet. So either: (a) your domain isn't big enough (b) you've set something up wrong somewhere (c) your solution is diverging
If it isn't (a), then check your settings (b), and if they look OK, try tightening the under-relaxation (c). |
|
December 7, 2007, 07:25 |
Re: ERROR IN CFX 11
|
#4 |
Guest
Posts: n/a
|
You can try to choose double precision in solver manager.
|
|
December 9, 2007, 02:42 |
Re: ERROR IN CFX 11
|
#5 |
Guest
Posts: n/a
|
Hi
Can you give a rough idea about the problem you are trying to solve. Basically all the responses given above will help.If your domain is really small to get the results converged, try putting an extension with free slip boundary. hope this helps |
|
December 10, 2007, 02:57 |
Re: ERROR IN CFX 11
|
#6 |
Guest
Posts: n/a
|
hello
it is a model of a mountain where on the top is a wind turbin, so the model is very big . is this helping you? thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Proper way to name boundaries on 2D model for use in CFX? | RossFS | ANSYS Meshing & Geometry | 4 | November 10, 2011 02:38 |
Pros and Cons for CFX, CFdesign, COMSOL | Val | Main CFD Forum | 3 | June 10, 2011 02:20 |
CFX pressure in Simulations problem | nasdak | CFX | 1 | April 14, 2010 13:22 |
PhD using CFX | Rui | CFX | 9 | May 28, 2007 05:59 |
CFX 4.4 installation problem | Pandu Sattvika | CFX | 1 | December 1, 2001 04:07 |