surface and base of cylinder
why the base of a cylinder can be recognized in CFX, but if I add a surface on the base of the cylinder, then CFX can't recognize the surface? I use ICEM-CFD to draw the geometry.
Thanks for your reply. Susan |
Re: surface and base of cylinder
Hi,
What do you mean by recognise the surface? Glenn Horrocks |
Re: surface and base of cylinder
I mean I want to add the surface to be the location of inlet boundary condition in cfx, but in the location list in CFX, there isn't the surface.
|
Re: surface and base of cylinder
if you create surface in ICEM after meshing the model.. it will not be recognisd in cfx.....
|
Re: surface and base of cylinder
Hi Susan,
You have to define the region as a part in ICEM then CFX-Pre will recognise it. Basics like this are covered in the tutorials. Glenn Horrocks |
All times are GMT -4. The time now is 22:56. |