|
[Sponsors] |
December 20, 2007, 00:28 |
ogrid in ogrid
|
#1 |
Guest
Posts: n/a
|
Could anybody tell me that whether it is possible to make a ogrid in ogrid?
Thanks. Susan |
|
December 20, 2007, 00:29 |
Re: ogrid in ogrid
|
#2 |
Guest
Posts: n/a
|
In ICEM CFD
|
|
December 20, 2007, 01:13 |
Re: ogrid in ogrid
|
#3 |
Guest
Posts: n/a
|
Yes. Split central block of an o-grid with o-grid option again two get o-grid in to o-grid.
Best luck, Chirag |
|
December 20, 2007, 03:54 |
Re: ogrid in ogrid
|
#4 |
Guest
Posts: n/a
|
Hello, to get an o grid inside another one, just use the ordinary split option and split the ogrid edge (o index). It is more simple and as same as using the o-grid option again inside the central block of older o-grid.
Regards Anantha |
|
December 20, 2007, 05:58 |
Re: ogrid in ogrid
|
#5 |
Guest
Posts: n/a
|
Hi,
I agree with Anantha. This is the most robust method. Using the O-grid split to split the interior square often results in problems in my case. Just split the radial edge of the first O-grid to get your second O-grid. Maurice |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] 2D Geom en street canyon model | fek66 | ANSYS Meshing & Geometry | 9 | June 23, 2015 05:22 |
[ICEM] Ogrid Initialization | Saikiran | ANSYS Meshing & Geometry | 0 | October 9, 2010 08:52 |
y+ Value & Aspect Ratio {Wind Tunnel Model} | FabioT | ANSYS Meshing & Geometry | 18 | October 5, 2010 15:00 |
Ogrid in curves | Mabell | ANSYS Meshing & Geometry | 2 | July 20, 2010 09:20 |
[ICEM] meshing 2d geometry with ogrid | vkrastev | ANSYS Meshing & Geometry | 3 | February 13, 2010 01:08 |