|
[Sponsors] |
January 8, 2008, 14:35 |
How to avoid interface separation?
|
#1 |
Guest
Posts: n/a
|
Hi,
I have an interface of two motion domains. Their mesh motion are set as unspecified. During the simulation one side of the interface is pulled, causing the separation of the interface sides. Is there a way to keep the two interface sides attached without prescribing mesh displacement (keeping the unspecified option)? Thanks a lot, Fabian |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 02:13 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 05:05 |
CFX Solver Memory Error | mike | CFX | 1 | March 19, 2008 08:22 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 16:55 |
Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 21:09 |