Domain Initialization in 2 phase flow using VOF
can i initialize a single domain with the volume fraction of the two phases at desired locations. e.g. start/initialize a closed channel flow simulation with water at the bottom and air on the top.
|
Re: Domain Initialization in 2 phase flow using VO
Hi,
Yes. The tutorial example free surface flow over a bump has an example of doing this. Glenn Horrocks |
Re: Domain Initialization in 2 phase flow using VO
I need this tutorial because my thesis deals with the subject. Thank you
|
Re: Domain Initialization in 2 phase flow using VO
Hi,
Look in the documentation, in the tutorial manual. It is described there. Glenn Horrocks |
All times are GMT -4. The time now is 23:58. |