optimizating flow (staticmixer tutorial)
 

Hi,

I am following the static mixer tutorial and when I load up the design explorer the only parameter's i can modify are the velocity inlets. I want to be able to modify the geometry. I did check the bock in design modeler to indicated a parameter. Is there something I missed?

Re: optimizating flow (staticmixer tutorial)
 

I've had this same problem, but with a structral simulation, so I hope this works!

Try this :

When in the project tab of Workbench

-Select the geometry once -look to the left under "Default Geometry Options" and delete the "DS" in the Parameters box.

This should publish the parameter for use in DesignXplorer.