 |
 |
 |
|
|
|
[Sponsors] | ||||
Fluid-fluid Interface between different surfaces |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 24, 2008, 06:07
|
Fluid-fluid Interface between different surfaces
|
#1 |
|
Guest
Posts: n/a
|
Good morning, guys.
I would like to know if it is ok/reliable to have a simulation with fluid-fluid interface between different surfaces, being one of them generated by a surface mesh extrusion though an helix and the other being just a cylindrical surface. This would be the best option for me to study a system which is very similar to a screw pump, and I managed to converge to a solution in CFX-Solver, but I would like to know if you guys have any idea on its reliability. Thank you so much in advance. Thiago Queiroz. |
|
|
||
|
February 24, 2008, 16:37
|
Re: Fluid-fluid Interface between different surfac
|
#2 |
|
Guest
Posts: n/a
|
Hi,
Yes, joining different meshes with GGI interfaces works well. Glenn Horrocks |
|
|
|
||
|
February 24, 2008, 16:50
|
Re: Fluid-fluid Interface between different surfac
|
#3 |
|
Guest
Posts: n/a
|
Thank you a bunch, Glenn.
I am getting good results, just wanted to confirm it. |
|
|
|
||
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
| increasing mesh quality is leading to poor convergence | tippo | CFX | 2 | May 5, 2009 10:55 |
| Boundary conditions at Fluid Solid interface (CHT) | michelle | CFX | 1 | April 21, 2008 04:06 |
| CFX Solver Memory Error | mike | CFX | 1 | March 19, 2008 07:22 |
| Turbulence damping at fluid interface | Eric | Siemens | 0 | October 4, 2002 14:32 |
Linear Mode
