 |
 |
 |
|
|
|
[Sponsors] | ||||
April 3, 2008, 15:14
|
Calculating mass flow rate
|
#1 |
|
Guest
Posts: n/a
|
Hi Guys
Can some one tell me please what is the relationship between mass flow rate (Ubar) and friction Reynolds number (Re tau). I need to calculate mass flow rate (Ubar) from Re tau. Thanks in advance |
|
|
||
|
April 3, 2008, 18:33
|
Re: Calculating mass flow rate
|
#2 |
|
Guest
Posts: n/a
|
Basically I am using periodic/cyclic BC at my inlet & outlet. I dont have U or P given, I have only Re tau. How can I calculte velocity from Re tau and then mass flow rate for my channel flow. Thanks in advance for answer.
cfd novice |
|
|
|
||
|
April 5, 2008, 06:26
|
Re: Calculating mass flow rate
|
#3 |
|
Guest
Posts: n/a
|
ok i read your message cal:mass flow rate: you know density of fluid and modal size volume.this will give. actually this is not correct way but that value near by calculating of original
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mass flow rate: calculation v/s computation | beguxa | FLUENT | 5 | December 2, 2018 21:02 |
| UDF to measure Mass Flow Rate | a.lynchy | Fluent UDF and Scheme Programming | 31 | October 4, 2018 14:10 |
| mass flow rate on the Iso-clip surface & interior | Sunil Gupta | FLUENT | 0 | April 22, 2008 09:29 |
| Calculating mass flow rate | cfd novice | FLUENT | 1 | April 3, 2008 18:31 |
| Determine mass flow rate along flow path | Atit Koonsrisuk | CFX | 2 | October 5, 2003 04:47 |
Linear Mode
