|
[Sponsors] |
April 4, 2008, 07:12 |
Torque Axis
|
#1 |
Guest
Posts: n/a
|
Hi everyone,
I'm just starting to use CFX and I would need to calculate the moment coefficient of a wing at different positions of its chord. I'm using the "torque()@'''" function in CFX-Post and I can't figure out how to specify an axis arround which the calculation is done. The only ones I CAN do the job with are Ox, Oy and Oz. Is it possible to specify a custom axis? Thanks for your help Arthur |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[DesignModeler] axis display disparity of model and triad | ram881973 | ANSYS Meshing & Geometry | 14 | November 18, 2020 01:21 |
High torque coefficient Cm for Vertical Axis Wind Turbine (VAWT) | tony00 | FLUENT | 11 | July 23, 2018 06:13 |
Torque calculation of 2D VAWT Wind Turbine | Anonymized_JL1 | FLUENT | 14 | September 26, 2013 03:35 |
torque calculation | mach000 | CFX | 2 | April 14, 2010 04:00 |
about use macro to compute torque in TASCflow | lancy | CFX | 0 | June 10, 2003 06:19 |