Error 001100279 floating point excepcion: Overflow

March 21, 2008, 15:05

Dear all,

I made some simulation in CFX 11 of sails boat. after 100 iter. an error comes up " Error 001100279 floating point excepcion: Overflow". In CFX's manual this error is about boundary conditions.

Some idea that the way to safe avoid this error??

Thanks!! J.

April 3, 2008, 04:33

i have that all the time. sorry... let me know if you know how to solve this.

best regards o.

April 6, 2008, 12:09

Dear all, I solved the problem. The issue was that the sail wasn't in a different part. Was a fluid and not a solid.

Sory about that!

March 21, 2008, 15:05	Error 001100279 floating point excepcion: Overflow	#1
Julieta Guest Posts: n/a	Dear all, I made some simulation in CFX 11 of sails boat. after 100 iter. an error comes up " Error 001100279 floating point excepcion: Overflow". In CFX's manual this error is about boundary conditions. Some idea that the way to safe avoid this error?? Thanks!! J.

April 3, 2008, 04:33	Re: Error 001100279 floating point excepcion: Over	#2
Ollimarc Guest Posts: n/a	i have that all the time. sorry... let me know if you know how to solve this. best regards o.

April 6, 2008, 12:09	Re: Error 001100279 floating point excepcion: Over	#3
Julian Guest Posts: n/a	Dear all, I solved the problem. The issue was that the sail wasn't in a different part. Was a fluid and not a solid. Sory about that!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ERROR: Floating point exception: Overflow	Elisabetta	CFX	23	July 14, 2018 06:57
block-structured mesh for t-junction	Robert@cfd	ANSYS Meshing & Geometry	20	November 11, 2011 04:59
Floating point exception: Overflow?	mike	CFX	4	December 15, 2009 17:30
Error #001100279 (floating point overflow)	Reza	CFX	4	September 24, 2009 15:15
[Gmsh] Gmsh and samplesurface	touf	OpenFOAM Meshing & Mesh Conversion	2	December 10, 2007 02:27