 |
 |
 |
|
|
|
[Sponsors] | ||||
May 10, 2012, 05:35
|
Swept tapered wing
|
#1 |
|
New Member
Stephen
Join Date: Feb 2012
Location: London
Posts: 6
Rep Power: 14  |
Hi guys I know that this is probably a basic question but I am massively struggling here.
I have to create a swept tapered wing in Ansys. I have the 2 airfoils coordinates and generated them in the geometry. I CANNOT seem to join them. Could anyone shed some light on how I can do this to create a 3-D wing. Any input would be greatly appreciated. |
|
|
|
|
|
May 10, 2012, 06:37
|
|
#2 |
|
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,697
Rep Power: 143 |
This sounds like a solid modelling question, not a CFX question. Try the geometry and meshing forum, or the forum for the solid modellign package you use.
|
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Forward swept wing simulation | abid | Siemens | 1 | June 16, 2012 13:26 |
| help needed for swept back wing simulation | shaker | Main CFD Forum | 3 | November 28, 2011 15:38 |
| Determing the flowfield on a swept wing | jd88 | Main CFD Forum | 0 | August 26, 2010 14:29 |
| [ICEM] Problems about meshing the swept wing with cylinder end cap | kepeng | ANSYS Meshing & Geometry | 3 | June 15, 2010 05:21 |
| How to mesh a swept wing in ICEM? | kepeng | ANSYS Meshing & Geometry | 0 | April 24, 2010 12:34 |
Linear Mode
