 |
 |
 |
|
|
|
[Sponsors] | ||||
May 29, 2008, 18:32
|
floating point precision
|
#1 |
|
Guest
Posts: n/a
|
Hi CFX users
I wanna increase floating point precision in CFX post. I wanna have more decimal places to my pressure values. How can I do that? If my question is not clear, please let me know I will try to elaborate. Thanks |
|
|
||
|
May 30, 2008, 20:07
|
Re: floating point precision
|
#2 |
|
Guest
Posts: n/a
|
Post always uses double precision. Whether your pressure is in single or double precision depends on whether you ran the solver in single or double precision.
To run the solver in double precision, go to the Solver tab on the launch panel in the Solver Manager and check "double". From the command-line add '-double'. -CycLone |
|
|
|
||
|
June 1, 2008, 12:48
|
Re: floating point precision
|
#3 |
|
Guest
Posts: n/a
|
Thank You Cyclone.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| MPI Error - simpleFoam - Floating Point Exception | scott | OpenFOAM Running, Solving & CFD | 3 | April 13, 2012 16:34 |
| block-structured mesh for t-junction | Robert@cfd | ANSYS Meshing & Geometry | 20 | November 11, 2011 04:59 |
| reactingFoam floating point exception | pajofego | OpenFOAM | 0 | November 6, 2010 17:29 |
| [Gmsh] Gmsh and samplesurface | touf | OpenFOAM Meshing & Mesh Conversion | 2 | December 10, 2007 02:27 |
| what's wrong about my code for 2d burgers equation | morxio | Main CFD Forum | 3 | April 27, 2007 10:38 |
Linear Mode
