 |
 |
 |
|
|
|
[Sponsors] | ||||
June 20, 2008, 04:11
|
CATIA TO ICEM/STAR
|
#1 |
|
Guest
Posts: n/a
|
Hi at all!!
is it possible to import a *.dat file (output from catia) in ICEM10 or STAR326, STAR402 ? greetings |
|
|
||
|
June 20, 2008, 12:49
|
Re: CATIA TO ICEM/STAR
|
#2 |
|
Guest
Posts: n/a
|
yes, in Icem there's an option named formatted point data you can use this import .dat file but the file should be carefully organized. If you want import in two points the coordinates of which is (0 0 0 )and (1 1 3) than the file may contain as follows: 0 0 0 1 1 3
just as far as I am concerned |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Importing CATIA V5 data into ccm+ | madcfd | STAR-CCM+ | 11 | November 7, 2017 02:16 |
| Problems with Hexa for CATIA | HSeldon | CFX | 0 | March 13, 2007 13:21 |
| catia to gambit | sulilatu | FLUENT | 1 | December 5, 2006 22:31 |
| CATIA: Exporting mesh to CFX | Jan | CFX | 1 | November 28, 2006 07:15 |
| export file from CATIA to I-DEAS to FLUENT | Pedro Clode | FLUENT | 6 | November 13, 2006 09:08 |
Linear Mode
