|July 10, 2008, 05:49||
I was trying to simulate a 2D compressor case with momentum source. My model is 2D and a single domain with blades and vanes as sub domains; I want to get the required pressure rise without rotating the domain since my geometry is of complex.
So I want to simulate the pressure and temperature raise across the blade through momentum source. In that if I define a cylindrical momentum source with axial component the pressure is not increasing and instead I am getting a pressure loss.
I imposed a mass flow inlet and a static pressure outlet.
Thnaks and regards Siva.K
|Thread||Thread Starter||Forum||Replies||Last Post|
|swak4foam building problem||GGerber||OpenFOAM Installation||54||April 24, 2015 16:02|
|Simulation of Axial Fan Flow using A Momentum Source Subdomain||Liam||CFX||28||July 16, 2013 08:24|
|pisoFoam compiling error with OF 1.7.1 on MAC OSX||Greg Givogue||OpenFOAM Programming & Development||3||March 4, 2011 18:18|
|DxFoam reader update||hjasak||OpenFOAM Post-Processing||69||April 24, 2008 01:24|
|DecomposePar links against liblamso0 with OpenMPI||jens_klostermann||OpenFOAM Bugs||11||June 28, 2007 17:51|