Surface Mesh in Workbench
I was wondering if there was anyway to either seed or specify an element type for a particular 2D region in the Workbench CFX mesher. I have a tet mesh that I am going to mate with a hex mesh and I wanted to specify pyramid elements at the interface to make mating the two grids easier. Any thoughts?
|
Re: Surface Mesh in Workbench
Hi,
No, this cannot be done. To get transition pyramid elements you need to mesh the enitre thing inside the normal workbench mesher. Glenn Horrocks |
All times are GMT -4. The time now is 14:46. |