 |
 |
 |
|
|
|
[Sponsors] | ||||
October 7, 2008, 09:17
|
animation
|
#1 |
|
Guest
Posts: n/a
|
I found that animation using CFX post is based on 24 frames per second.
Is there any way that I can control the number of frames per second? Say, 12 frames per second? Regards, Sungho |
|
|
||
|
October 7, 2008, 09:45
|
Re: animation
|
#2 |
|
Guest
Posts: n/a
|
Yes you can control the no. of frames by clicking "option" button and then in popup you can go in the advanced tab where you can change the no.of frames, but i could see that you can only increase the no.of frames
|
|
|
|
||
|
October 7, 2008, 09:49
|
Re: animation
|
#3 |
|
Guest
Posts: n/a
|
Hi Sungho,
To change the frame rate you must click on the 'options' tab which is located in the bottom right corner of the 'animation' window. Once the 'option' window opens click on 'advanced' and select the frame rate that you want. If you are performing a 'keyframe animation' you can also choose an animation speed in the 'options' tab. Regards, Federico |
|
|
|
||
|
October 7, 2008, 10:16
|
Re: animation
|
#4 |
|
Guest
Posts: n/a
|
Thank you very much.
Regards, Sungho |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Creating animation through TUI | wawa | FLUENT | 27 | November 5, 2021 03:17 |
| Cropping animation spatially | smonsch | ANSYS | 0 | September 3, 2009 14:09 |
| Multiblock animation in Tecplot. | Simon | Tecplot | 4 | February 10, 2006 10:27 |
| Animation query..newbie qn | derick | FLUENT | 2 | December 9, 2005 09:45 |
| Animation in Tecplot | ryoga | Tecplot | 0 | February 18, 2002 11:19 |
Linear Mode
