|
[Sponsors] |
October 30, 2008, 10:41 |
Workbench Question - Relative Error Spacing
|
#1 |
Guest
Posts: n/a
|
I was wondering if anyone had any experiance using the relative error face/edge spacing option? The manual doesn't go into a lot of detail about how to determine the value for the relative error. It defines the error as delta r / r and says to use a value between 4e-5 and .292 but doesn't provide any guidelines; does anyone have any experience or know any general guidelines for picking a value?
Thanks John |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ansys 12 Workbench 2D surface question | justincase | ANSYS Meshing & Geometry | 4 | February 24, 2020 04:22 |
question about uds | tanven | FLUENT | 2 | July 5, 2015 12:22 |
Question about Table applicaiton. | universez | OpenFOAM Running, Solving & CFD | 0 | January 12, 2010 21:31 |
question about governing equation in CFX using rotating/non rotating reference frame | rystokes | CFX | 0 | January 12, 2010 07:14 |
CHANNEL FLOW: a question and a request | Carlos | Main CFD Forum | 4 | August 23, 2002 06:55 |