Home > Forums > Software User Forums > ANSYS > CFX

Hybrid Mesh on ICEM

Mark Forums Read

Reply

Search this Thread

October 31, 2008, 17:25	Hybrid Mesh on ICEM	#1
alvio Guest Posts: n/a	Hi, One of the steps to built an hybrid mesh on ICEM is to transform geometry to move the location of the active body to the second domain to be mesh. However when I access the option TRANSFORM GEOMETRY, as indicated in the tutorial of the hybrid tube, it does not provide any option allowing me to move the body to the domain of interest. Have anyone any hint of how to proceed? Regards, Alvio

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Negative volume error in hybrid mesh	siw	ANSYS Meshing & Geometry	4	September 3, 2014 05:25
Export 2D mesh from ICEM to Fluent	BuilttoSpill	ANSYS Meshing & Geometry	4	August 28, 2010 08:16
problem when converting mesh (made by ICEM) using fluentMeshToFoam	Forrest_Lei	OpenFOAM	11	October 16, 2009 06:28
Hex-Tet Mesh Merge in ICEM	Tristan	CFX	1	September 26, 2008 05:40
ICEM 10 mesh question	DAK565656	CFX	6	May 8, 2007 12:16

All times are GMT -4. The time now is 21:50.