CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   CFX (http://www.cfd-online.com/Forums/cfx/)
-   -   Axisymmetric Modelling using 2D extrusion (http://www.cfd-online.com/Forums/cfx/26650-axisymmetric-modelling-using-2d-extrusion.html)

Steve November 12, 2008 13:05

Axisymmetric Modelling using 2D extrusion
 
I'm having some problems with the quality of my mesh when using a partially extruded mesh (rotated). At at the axis where my mesh is revoled aroun, I am experiencin very bad mesh orthogonality, which is affecting my solutions

Is there something i can do to counter this geometrically or in CFX-mesh?

Advance thanks

Steve


All times are GMT -4. The time now is 02:44.