Work bench design modleler

November 20, 2008, 10:57

Hi,

I am trying to extrude (add matreial) a face normally in Workbench design modeler. The face is from another extrude (cut) operation. So I used NamedSelection but can not set the direction vector. Its none(normal) in the detail view. So giving invalid direction vector after generation.

Any suggestion ?

Regards

Faruk

November 21, 2008, 13:59

you have to select an edge (indicating normal vector) to extrude from a face. The edge must be there.

November 20, 2008, 10:57	Work bench design modleler	#1
Faruk Guest Posts: n/a	Hi, I am trying to extrude (add matreial) a face normally in Workbench design modeler. The face is from another extrude (cut) operation. So I used NamedSelection but can not set the direction vector. Its none(normal) in the detail view. So giving invalid direction vector after generation. Any suggestion ? Regards Faruk

November 21, 2008, 13:59	Re: Work bench design modleler	#2
KUMAR Guest Posts: n/a	you have to select an edge (indicating normal vector) to extrude from a face. The edge must be there.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Heat exchanger design	sakthi	Main CFD Forum	6	September 3, 2022 01:22
[Other] Connecting 3D bodies in Ansys Design Modeler	chipper	ANSYS Meshing & Geometry	4	January 25, 2018 09:45
Design Integration with CFD?	John C. Chien	Main CFD Forum	19	May 17, 2001 15:56
Info: Short Course On Thermal Design of Electronic Equipment	Arnold Free	Main CFD Forum	0	August 10, 1999 10:18
Yacht Design and CDF	Astrid Barros	Main CFD Forum	2	August 25, 1998 14:18