|
[Sponsors] |
December 16, 2008, 13:41 |
Bad params in create_edge_pars
|
#1 |
Guest
Posts: n/a
|
Dear ICEM users,
I am trying to hex mesh a complex 3D piping. While meshing, I got the error message written in subject line. Just to check, I opened a new ICEm session, created a cylinder and made O-grid. For this simplified geometry, I got the same error message. In fact, for all subsequent meshing, I am getting this error message even though the mesh generated has no quality problem whatsoever. Any comment would be highyl appreciated! thanks, Amod |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[mesh manipulation] Removing bad cell using subsetmesh-good???? | nileshjrane | OpenFOAM Meshing & Mesh Conversion | 1 | February 23, 2017 10:23 |
how to deal with bad quality cells? | phsieh2005 | OpenFOAM | 3 | July 20, 2011 09:35 |
ICEM Extrude faces - Edge params. | Santiago Orrego. | CFX | 0 | June 19, 2007 12:08 |
Bad OpenGL Performance with FIRE GL2 using GAMBIT | Volker Pawlik | FLUENT | 1 | December 1, 2003 12:38 |
Problems of Duns Codes! | Martin J | Main CFD Forum | 8 | August 14, 2003 23:19 |