CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > CFX

FSI interface

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   December 1, 2008, 22:52
Default FSI interface
  #1
Crage
Guest
 
Posts: n/a
Hi,guys

I am recently doing FSI simulation about a centrifugal pump impeller with CFX&Workbench 11.In the workbench simulation(CSD),I have defined a Fluid-Solid interface with blades(for example),and the .inp file would includ ANSYS interface FSIN_1 which will be set to the corresponding CFD boundray(bladewall) in CFX.

Because of the pump especially impeller as a rotor(domain is rotating in CFX),bladewall would be at different location in coming timesteps,but FSIN_1 seemed like being stationary in WB simulation.

And my point is,though FSIN_1 and bladewall were in the same location with respect to the global Cartesian coordinate system in two solvers at very beginning when I set up the simulatin,does FSIN_1 still send data normally to bladewall in following timesteps automatically?

Thanks a lot!

Crage
  Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Wind turbine simulation Saturn CFX 58 July 3, 2020 02:13
User-defined force transfer across FSI interface vivekcfd CFX 7 March 10, 2010 21:43
RPM in Wind Turbine Pankaj CFX 9 November 23, 2009 05:05
Convective Heat Transfer - Heat Exchanger Mark CFX 6 November 15, 2004 16:55
Replace periodic by inlet-outlet pair lego CFX 3 November 5, 2002 21:09


All times are GMT -4. The time now is 04:47.