|
[Sponsors] |
December 4, 2008, 15:36 |
How to make a "baffle" in ICEM-CFX
|
#1 |
Guest
Posts: n/a
|
Hi, I've recently met a problem of using baffle in a 3D CFD model. I can draw a surface(2D plane)(which I want to use as a baffle) in the geometry model in ICEM-CFX and then producing the mesh, but the surface can not be recognized by CFX-pre.
Could someone give me any suggestions on this? Thanks in advance. Joe |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to make the water slightly compressible in CFX? | womo | CFX | 14 | February 12, 2020 07:20 |
Import Mesh from ICEM CFD to CFX | Andre Almeida | CFX | 16 | April 19, 2016 04:42 |
ICEM CFD to CFX geometry and mesh | Luca | CFX | 6 | February 4, 2010 17:31 |
how to export icem mesh to cfx? | Michael | CFX | 1 | May 3, 2008 14:35 |
ICEM 10 mesh scale foe CFX | Korsh Mik | CFX | 2 | October 7, 2005 10:07 |