|December 16, 2008, 14:41||
Bad params in create_edge_pars
Dear ICEM users,
I am trying to hex mesh a complex 3D piping. While meshing, I got the error message written in subject line. Just to check, I opened a new ICEm session, created a cylinder and made O-grid.
For this simplified geometry, I got the same error message. In fact, for all subsequent meshing, I am getting this error message even though the mesh generated has no quality problem whatsoever.
Any comment would be highyl appreciated!
|Thread||Thread Starter||Forum||Replies||Last Post|
|how to deal with bad quality cells?||phsieh2005||OpenFOAM||3||July 20, 2011 09:35|
|Removing bad cell using subsetmesh-good????||nileshjrane||OpenFOAM Mesh Utilities||0||September 4, 2010 15:49|
|ICEM Extrude faces - Edge params.||Santiago Orrego.||CFX||0||June 19, 2007 12:08|
|Bad OpenGL Performance with FIRE GL2 using GAMBIT||Volker Pawlik||FLUENT||1||December 1, 2003 13:38|
|Problems of Duns Codes!||Martin J||Main CFD Forum||8||August 14, 2003 23:19|