Mesh in ANSYS-WB --- How to create CFX-file /*.gtm-file

ehrenwirth · April 2, 2009, 15:03

Hi there!

I just watched a pretty cool tutorial in where different mesh-strategies are shown. You can watch it at:

http://www.ansys.com/demoroom/zoom.aspx?d=97

This guy builds up his mesh in ANSYS-WB and in the very end (somewhere around minute 19:00) he is just clicking "write fluent file".

How can i do this for ansys-cfx? Or can i only mesh in cfx-mesh?

Thanks in advance!

mvoss · April 3, 2009, 07:33

hi, save the desired mesh under "save as ..." and then load the cmdb-file in CFX-Pre. You have to choose Ansys Workbench as input in the meshselection mask.

neewbie

ehrenwirth · April 4, 2009, 18:16

Hi!

Thanks for your reply! It was so simple, thank you!!!

April 2, 2009, 15:03	*Mesh in ANSYS-WB --- How to create CFX-file /.gtm-file**	#1
ehrenwirth New Member Join Date: Mar 2009 Posts: 21 Rep Power: 17	Hi there! I just watched a pretty cool tutorial in where different mesh-strategies are shown. You can watch it at: http://www.ansys.com/demoroom/zoom.aspx?d=97 This guy builds up his mesh in ANSYS-WB and in the very end (somewhere around minute 19:00) he is just clicking "write fluent file". How can i do this for ansys-cfx? Or can i only mesh in cfx-mesh? Thanks in advance!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[blockMesh] BlockMesh FOAM warning	gaottino	OpenFOAM Meshing & Mesh Conversion	7	July 19, 2010 14:11
Importing Ansys .cdb mesh and geometry into CFX 11	Tom	CFX	1	February 18, 2008 11:08
Ansys mesh and CFX	anna	CFX	3	August 28, 2006 06:55
reading Promixus mesh file in CFX 4	JMM	CFX	5	January 30, 2002 08:58
PHI file structure	Eugene	Phoenics	9	November 2, 2001 22:00

April 3, 2009, 07:33		#2
mvoss Senior Member Matthias Voß Join Date: Mar 2009 Location: Berlin, Germany Posts: 449 Rep Power: 20	hi, save the desired mesh under "save as ..." and then load the cmdb-file in CFX-Pre. You have to choose Ansys Workbench as input in the meshselection mask. neewbie

April 4, 2009, 18:16		#3
ehrenwirth New Member Join Date: Mar 2009 Posts: 21 Rep Power: 17	Hi! Thanks for your reply! It was so simple, thank you!!!