 |
 |
 |
|
|
|
[Sponsors] | ||||
April 14, 2009, 04:59
|
spray modelling
|
#1 |
|
New Member
sajed hadi bafekr
Join Date: Apr 2009
Posts: 2
Rep Power: 0  |
hi.
I have modeled pressure swirl injectors in fluent 6.3. LISA and TAB are primary and secondary models that I have used. my geometry is 2D axisymmetric. but I dont know how fluent choose the diameter of drops in parcels after primary breakup. I know that all parcels have the same mass. LISA give me a SMD. and fluent uses the rosin rammler distribuition to set the parcels diameter. but how? my email is " patrice_1393@yahoo.com ". I am always online in yahoo messenger. thanks a lot. Last edited by patrice1393; April 16, 2009 at 03:42. Reason: no reason |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| process vessel spray ball modelling | Dan O'Brien | CFX | 4 | May 17, 2022 01:28 |
| CFD spray modelling | Kumar | FLUENT | 1 | September 14, 2012 12:56 |
| spray modelling | bohis | FLUENT | 0 | January 19, 2008 14:47 |
| question about dense spray modelling | Dr. shafik M. El-Bahnasy | Phoenics | 0 | February 18, 2007 02:46 |
| Gasoline spray modelling | Enrico | Main CFD Forum | 2 | May 26, 1999 15:38 |
Linear Mode
