|April 14, 2009, 04:59||
sajed hadi bafekr
Join Date: Apr 2009
Posts: 2Rep Power: 0
I have modeled pressure swirl injectors in fluent 6.3. LISA and TAB are primary and secondary models that I have used. my geometry is 2D axisymmetric.
but I dont know how fluent choose the diameter of drops in parcels after primary breakup. I know that all parcels have the same mass. LISA give me a SMD. and fluent uses the rosin rammler distribuition to set the parcels diameter. but how?
my email is " firstname.lastname@example.org ". I am always online in yahoo messenger.
thanks a lot.
Last edited by patrice1393; April 16, 2009 at 03:42. Reason: no reason
|Thread||Thread Starter||Forum||Replies||Last Post|
|CFD spray modelling||Kumar||FLUENT||1||September 14, 2012 12:56|
|spray modelling||bohis||FLUENT||0||January 19, 2008 15:47|
|process vessel spray ball modelling||Dan O'Brien||CFX||2||November 6, 2007 11:10|
|question about dense spray modelling||Dr. shafik M. El-Bahnasy||Phoenics||0||February 18, 2007 03:46|
|Gasoline spray modelling||Enrico||Main CFD Forum||2||May 26, 1999 15:38|