Nonoverlap Heat Transfer Conditions

Tristan · April 27, 2009, 15:52

I have a domain interface connecting non-matching areas (cylinder wall and ports) using a GGI (cylinder is a hexa mesh and ports are meshed with tets and inflation layers). For the larger area (cylinder wall), I have to specify Nonoverlap Conditions and I'm wondering why "Adiabatic" is the only available choice for Heat Transfer. I'd like to be able to set the cylinder wall to a constant temperature everywhere except where it overlaps with the ports.

Does anyone have any experience with this?

Thanks,

Tristan

ghorrocks · April 27, 2009, 21:35

Hi,

Adiabatic is the only option so far implemented. I don't know if V12 has more options available, ask your CFX support person. This might also be a beta feature which is not visible in the GUI - again, ask your support person.

Glenn Horrocks

April 27, 2009, 15:52	Nonoverlap Heat Transfer Conditions	#1
Tristan Member Tristan Burton Join Date: Mar 2009 Posts: 43 Rep Power: 17	I have a domain interface connecting non-matching areas (cylinder wall and ports) using a GGI (cylinder is a hexa mesh and ports are meshed with tets and inflation layers). For the larger area (cylinder wall), I have to specify Nonoverlap Conditions and I'm wondering why "Adiabatic" is the only available choice for Heat Transfer. I'd like to be able to set the cylinder wall to a constant temperature everywhere except where it overlaps with the ports. Does anyone have any experience with this? Thanks, Tristan

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
No results for solid domain	Gary Holland	CFX	10	March 13, 2009 03:30
How can I increase Heat Transfer at Domain Interf?	B.Simon	CFX	3	October 28, 2008 18:53
Water vapour condensation in CFX-5.7.1	hdj	CFX	1	November 27, 2005 07:15
Heat Transfer & Boundary Conditions across 2D wall	SAAD	Main CFD Forum	6	March 13, 2005 12:42
Convective Heat Transfer - Heat Exchanger	Mark	CFX	6	November 15, 2004 15:55

April 27, 2009, 21:35		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,696 Rep Power: 143	Hi, Adiabatic is the only option so far implemented. I don't know if V12 has more options available, ask your CFX support person. This might also be a beta feature which is not visible in the GUI - again, ask your support person. Glenn Horrocks