|
[Sponsors] |
May 20, 2009, 08:34 |
Ash/Air multiphase heat exchanger
|
#1 |
New Member
Antonio P.
Join Date: Mar 2009
Posts: 10
Rep Power: 17 |
I'm simulating an heat exchange between air and ash inside a multiphase cooler. I did a preliminar analysis supposing a restitution coefficient for walls equal to 1, and the run reached quickly convergence.
But when I switched the restitution coefficient for walls equal to 0.05, the run didn't reach convergence. Wich parameters could I modify or set to solve the problem? Thanx |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Concentric tube heat exchanger (Air-Water) | Young | CFX | 5 | October 6, 2008 23:17 |
Heat Exchanger Efficiency | NTM | FLUENT | 0 | September 19, 2008 02:19 |
Pressure drop in a heat exchanger | Diana | FLUENT | 5 | December 13, 2007 09:33 |
Ansys CFX10: multiphase reaction heat problem | CFDS | CFX | 1 | September 20, 2006 23:09 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |