CFX-11 Simulation -- CFD Online Discussion Forums

September 11, 2009, 02:59	CFX-11 Simulation	#1
Jwala.R New Member Jwala Join Date: May 2009 Posts: 10 Rep Power: 16	Hi, While simulating Rotor-Stator case I am getting error as Could nor invert control surface Ap and then case gets crashed. Is this error related to mesh ?.If so how to get the location where mesh quality need to be improved .But my mesh has fulfilled the mesh quality criteria. In Same case sometimes wall at outlet starts to develop and after few iterations case gets crashed. Even reducing the back pressure at exit didn't work. I am using coarse mesh. Please suggest. Regards, Jwala.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Pros and Cons for CFX, CFdesign, COMSOL	Val	Main CFD Forum	3	June 10, 2011 02:20
Problems on H2/air CFX simulation	xulixian	OpenFOAM Running, Solving & CFD	2	April 14, 2009 15:00
PhD using CFX	Rui	CFX	9	May 28, 2007 05:59
2D simulation - ICEM meshing for CFX question	Ben Makhal	CFX	5	April 11, 2007 08:44
Simulation of turbine cascade in CFX.	Jonas Pedro Caumo	CFX	0	December 9, 2006 13:54

All times are GMT -4. The time now is 18:43.