|September 11, 2009, 02:59||
Join Date: May 2009
Posts: 10Rep Power: 8
While simulating Rotor-Stator case I am getting error as Could nor invert control surface Ap and then case gets crashed.
Is this error related to mesh ?.If so how to get the location where mesh quality need to be improved .But my mesh has fulfilled the mesh quality criteria.
In Same case sometimes wall at outlet starts to develop and after few iterations case gets crashed.
Even reducing the back pressure at exit didn't work.
I am using coarse mesh.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Pros and Cons for CFX, CFdesign, COMSOL||Val||Main CFD Forum||3||June 10, 2011 02:20|
|Problems on H2/air CFX simulation||xulixian||OpenFOAM Running, Solving & CFD||2||April 14, 2009 15:00|
|PhD using CFX||Rui||CFX||9||May 28, 2007 05:59|
|2D simulation - ICEM meshing for CFX question||Ben Makhal||CFX||5||April 11, 2007 08:44|
|Simulation of turbine cascade in CFX.||Jonas Pedro Caumo||CFX||0||December 9, 2006 14:54|