CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   CFX (http://www.cfd-online.com/Forums/cfx/)
-   -   choosing faces in CFX with imported WB mesh (http://www.cfd-online.com/Forums/cfx/70788-choosing-faces-cfx-imported-wb-mesh.html)

mactech001 December 6, 2009 03:29

choosing faces in CFX with imported WB mesh
 
Dear all,

I would like to import the mesh done in Workbench into CFX to perform FSI analysis. The trouble i face is that once the mesh is imported into CFX, i have to choose particular faces to define inlet, outlet, heat source and air convection faces.

Can i define/name these boundary faces in Workbench first and then once imported in CFX, i can still easily choose these named faces in CFX to define the boundaries please?

Thank you for your kind attention, and i look forward to hear of any comments/tips.

cfdman December 7, 2009 03:30

Hello mactech001,

It's possible to name bodies,faces and lines in WB Meshing. You have to make "name selection" in Meshing. Highlight a face, right click select "name selection" then write a name. Generate.
Then you can select this faces in CFX and you can give Boundary Conditions.

I hope it's helpfull


All times are GMT -4. The time now is 10:13.